Dear Juan,
Lately, since a couple of updates ago, I run into an halt when error detected instead of a continue, although Continue was selected.
I've only experienced it running the SubframeSelector when measuring subframes.
When this happens close at the end of the series, one has to run the whole process again, it doesn't reuse previous calculations made.
If you or someone of your team could have a look at it, It would be most appreciated.
Of course I may be doing something wrong as well,
all feedback appreciated.
Thanks,
Johan
Lately, since a couple of updates ago, I run into an halt when error detected instead of a continue, although Continue was selected.
I've only experienced it running the SubframeSelector when measuring subframes.
When this happens close at the end of the series, one has to run the whole process again, it doesn't reuse previous calculations made.
If you or someone of your team could have a look at it, It would be most appreciated.
Of course I may be doing something wrong as well,
all feedback appreciated.
Thanks,
Johan