Author Topic: Removing Vertical Bands - KAI-11000 sensor  (Read 603 times)

Offline Astrodoc

  • PixInsight Old Hand
  • ****
  • Posts: 356
    • View Profile
    • AstroDoc - Astrophotography by Ron Brecher
Removing Vertical Bands - KAI-11000 sensor
« on: 2016 September 11 07:02:11 »
It looked like there was work being done on a PI tool to fix these problems - there are threads involving Bob Franke, the author of CCD BandAid. But the conversation seems to have stopped a couple of years ago.

Has any progress been made?

Clear skies,
Ron
Clear skies,
Ron

Offline sreilly

  • PixInsight Padawan
  • ****
  • Posts: 757
    • View Profile
    • Imaging at Dogwood Ridge Observatory
Re: Removing Vertical Bands - KAI-11000 sensor
« Reply #1 on: 2016 September 11 09:03:40 »
I know I had some strange patterns on my chip once and it seems using an additional ferrite around the power supply took care of it. One thing to check is cables and power supply. I always try to isolate my power from the rest of the cables to avoid any electrical interference possibilities. It's a carry over from my communication days in HVAC computer zoning systems I guess.

Steve
Steve
www.astral-imaging.com
AP1200
OGS 12.5" RC
Tak FSQ-106ED
ST10XME/CFW8/AO8
STL-11000M/FW8/AO-L
Pyxis 3" Rotator
Baader LRGBHa Filters
PixInsight/MaxIm/ACP/Registar/Mira AP/PS CS5

Offline pfile

  • PTeam Member
  • PixInsight Jedi Grand Master
  • ********
  • Posts: 4137
    • View Profile
Re: Removing Vertical Bands - KAI-11000 sensor
« Reply #2 on: 2016 September 11 12:04:11 »
back around when bob posted that stuff i thought i read something about the problem being how the chip was clocked by external the circuitry... thought that there were FPGA upgrades from at least some camera manufacturers that were supposed to fix the problem...?

rob