Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - vagrom

Pages: [1]
1
General / Re: Linux Version - Star Align Not Working
« on: 2018 November 03 12:29:15 »
Found the issue. The files were corrupted. Not sure how PI was able to calibrate and debayer though.

2
General / Re: Linux Version - Star Align Not Working
« on: 2018 November 02 14:48:33 »
I wonder if it is due to the 32 cores on my AMD 1950 threadripper.

I tried to align frame_1 with frame_1 through frame_19 and frame_15 fails with error stating "0 start pair matches found..."

I then try again but this time align frame_1 with frame_15 through frame_19 and star align works on all 5 frames.

Could it be a bug in the parallelism of the StarAligment algorithm?

3
General / Linux Version - Star Align Not Working
« on: 2018 October 28 08:13:11 »
I recently built a new computer and it is running Ubuntu 18.04. I installed a copy of PixInsight and updates. Was able to get PixInsight working.

First processing run, I found that I could not register the images. I ran the Batch Preprocesing Script and then StarAlign on the calibrated images. Either would register: batch script registered none and StarAlign like 6 out of 58. Using Blink the subs are good and only movement is the dithering.

I was able to use my old Win10 computer and that PixInsight version was able to calibrate and register the images no problem.

Any reason why a fresh Linux install would not StarAlign?

Thanks,
Steven

4
Bug Reports / Re: Arcsinh stretch not showing after update
« on: 2017 October 12 08:29:24 »
I looked in the Program Files\pixinsight\bin folder and saw the Arcsinh Stretch dll. I went to Process/Modules/Install Module and searched the directory and it found the module. I then manually installed. It now shows up under Intensity Transformations.


5
Bug Reports / Arcsinh stretch not showing after update
« on: 2017 October 12 07:27:02 »
On my Win64 machine, I just updated PixInsight and after restart, the arcsinh stretch process does not show up. I can go to "view installed updates" as see the update containing the stretch has be installed.

I did have the non-official module loaded, but I had to remove it as it was not working.

Any thoughts other than fresh install of PixInsight?

6
General / Automate processing multiple folders
« on: 2017 August 22 05:55:15 »
With the eclipse, I have a set of folders (one every 2 minutes during the eclipse) with captures. I need to run Image Calibration, Debayer, and FFTRegistration to each folder.

To automate this can I use Image Container or do I need to write a script?

Any pointers would be helpful.

Thanks!

Pages: [1]