Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - Starcruiser

Pages: [1]
1
General / Image Calib Refuses To Apply Dark
« on: 2018 September 27 12:43:51 »
Been trying to get to the bottom of this for two days.  Gave up and did Preprocessing in CCDStack.  Acts as if the dark is ignored in PI.  Here are two screen shots of my settings.

2
General / Mouse Over Info
« on: 2018 March 28 12:51:12 »
Is there a way to increase the mouse over info panel where all the help information can be read?  A lot of it is clipped at the bottom and cannot be seen.  At least I have not discovered it.

Thanks,
Bill

3
General / GREEN Channel Vertical Banding
« on: 2018 March 25 06:19:06 »
Since I using a dual-rig and camera setup for simultaneous acquisition I have run into a problem in processing only the Green channel.  Blue and Red combine fine even though the scaling is different PI has been handling this fine until now.  The vertical banding in the Green channel only appears while using the StarAlignment module.  Separate and apart the Green channels from the ST8300M subs and 168C subs are fine.  Once I align and scale the QHY168C green subs with the ST8300M green subs then QHY168C green subs become banded.

I have run out of combinations I can think of to localize this issue but have come at a dead end.  I do not understand why my process works fine for Red and Blue but Green gets messed up.  Until I can get this corrected I cannot use ImageIntegration on the green channel.

Attached is my PI desktop screen cap, Green channel is on the far left.  As you can see Red and Blue have no banding.

Please let me know what else I can post to assist with this issue.

Thanks,
Bill

4
General / Process Icons Not Visible After Loading
« on: 2017 September 22 15:21:28 »
Allowed PI to do it's update after startup which appeared to be five files.  Restarted PI after the update installation all appeared fine at this point.

Went into Process to Load Process Icons and chose the file, Process Console Showed them being loaded into the workspace.  The are not visible on
the screen.  Tried again and PI gives me a warning that the current process icon set has been modified and is unsaved...Throw away all process icons?
Y/N

So where are they hiding.  Process Console reports 6 icons are loaded.

Windows7-64.

All was fine until this morning's update.

Thanks,
Bill

5
General / .xisf being changed back to .fit
« on: 2017 August 07 13:59:59 »
Just started using v1.8.5 and after loading my .xisf image files into StarAlignment all the files are processed and saved with .fit extenders in the output directory.
What is causing the change?  I do not see any setting in StarAlignment that causes this change.

Thanks

Pages: [1]