Wrong Image Geometry during the BLINK process

[wrightslakeobservatory]

Hi there. I am new to this board and to pixinsight. I believe I am in over my head and know where new as smart as most of you. But now I have to at least give it a try.

 I have LRGB Fits that I am trying to load during the BLINK process. Half way through a error box pops up and says "Wrong Image Geometry. Any suggestions on what might be causing this error?

The Luminance is 3326 x 2504 pixels while the RGB are all 1632 x 1252 pixels. Do these all have to be the same? Also would this have been caused by binning the RGB as 2x2 while the Lum was 1x1?

Thanks so much and again, so sorry I am miles behind you folks.

[Alejandro Tombolini]

Hi, welcome to the forum. Blink tool will expect images with the same geometry.

You can make an inspection of the RGB images and other of the L images

Saludos, Alejandro.

[wrightslakeobservatory]

Yes that is what the response from pixingsight referred. So how do I do that?