Software Development > PCL and PJSR Development

Image Acquisition in PixInsight (Was: When will Pixinsight...)

<< < (26/28) > >>

David Raphael:
I just wanted to follow up on this thread and let everyone know that I am going to be spending time on this once again.

If anyone is interested in details on where the project is at this point...just reply to this thread :)

Carlos Milovic:
Hi David!
I know for certain that many people are looking at this :) And also I'm very interested in the results.
If you get PI to capture Canon cameras, and control an autoguider, you'll be my hero. ;)

georg.viehoever:
I always wondered what happened to this project. Yes, please, go ahead!
Georg

Alejandro Tombolini:

--- Quote from: Carlos Milovic on 2012 December 13 01:56:11 ---If you get PI to capture Canon cameras, and control an autoguider, you'll be my hero. ;)

--- End quote ---

+1

vicent_peris:
Hi David,

You know I was always very interested in your project. All I can do for now is to give you a list of the instruments I have to do the betatesting:

- Cameras: FLI Proline, Apogee Alta, Lumenera Skynyx, Starlight SXVR and Superstar.
- Filter wheels from FLI.
- Mounts: Paramount, Astelco NTM, Astro Electronic FS2.
- Tubes (focuser): Planewave CDK, Optec.
- Meteo station: Vaisala WTX520 and Davis Instruments.

As far as I know, there's drivers for Linux only for FLI, Paramount, Astelco NTM and Davis Instruments. But I don't know if you're planning to port your modules to Linux.


Best regards,
Vicent.

Navigation

[0] Message Index

[#] Next page

[*] Previous page